Configuring The Dfl-500 To Run In Transparent Mode - D-Link DFL-500 User Manual

·
Type admin and press Enter.
The following prompt appears:
Type ? for a list of commands.

Configuring the DFL-500 to run in Transparent mode

Use the information that you gathered in
Changing to Transparent mode
·
Login to the CLI if you are not already logged in.
·
Switch to Transparent mode. Enter:
set firewall opmode transparent
After a few seconds, the following prompt appears:
D-Link login:
·
Type admin and press Enter.
The following prompt appears:
Type ? for a list of commands.
·
Confirm that the DFL-500 has switched to Transparent mode. Enter:
get system status
The CLI displays the status of the DFL-500. The last line shows the current operation mode.
Version:DFL-500 2.26,build041,020617
virus-db:3.1(06/13/2002 15:30)
ids-db:1.0(06/05/2002 11:33)
Serial Number:FGT-502801021075
Operation mode: Transparent
Configuring the Transparent mode management IP address
·
Login to the CLI if you are not already logged in.
·
Set the IP address and netmask of the Management IP to the IP address and netmask that you recorded
in Transparent mode
set system manageip ip <IP Address> <Netmask>
Example
set system manageip ip 10.10.10.2 255.255.255.0
·
Confirm that the address is correct. Enter:
get system manageip
The CLI lists the Management IP address and netmask.
Configure the Transparent mode default gateway
·
Login to the CLI if you are not already logged in.
·
Set the default route to the Default Gateway that you recorded in
set system manageip gateway <IP Address>
Example
set system manageip gateway 192.168.1.20
You have now completed the initial configuration of the DFL-500 and you can proceed to connect the
DFL-500 to your network using the information in
DFL-500 User Manual
Transparent mode settings
settings. Enter:
to complete the following procedures.
Transparent mode
Connecting to your network
settings. Enter:
that follows.
27