Configuring The Dfl-1000 To Run In Transparent Mode - D-Link DFL-1000 User Manual

Hide thumbs Also See for DFL-1000:
Table of Contents

Advertisement

set system interface dmz ip <IP Address> <Netmask>
Example
set system interface dmz ip 192.168.1.1 255.255.255.0
Confirm that the addresses are correct. Enter:
get system interface
The CLI lists the IP address and netmask settings for each of the DFL-1000 interfaces.
Configure the NAT mode default gateway
Login to the CLI if you are not already logged in.
Set the default route to the Default Gateway IP Address that you recorded in
Enter:
set system route add 0.0.0.0 0.0.0.0 gw <IP Address> dev external
Example
set system route add 0.0.0.0 0.0.0.0 gw 204.23.1.2 dev external
You have now completed the initial configuration of the DFL-1000 and you can proceed to connect
the DFL-1000 to your network using the information in

Configuring the DFL-1000 to run in Transparent mode

The procedures in this section describe how to use the CLI to configure the DFL-1000 to run in
Transparent mode.
Changing to Transparent mode
Login to the CLI if you are not already logged in.
Switch to Transparent mode. Enter:
set system status opmode 2
The following prompt appears:
D-Link login:
Type admin and press Enter.
The following prompt appears:
Type ? for a list of commands.
Confirm that the DFL-1000 has switched to Transparent mode. Enter:
get system status
The CLI displays the status of the DFL-1000. The last line shows the current operation mode.
Version:DFL-1000 2.20,build011,020315
virus-db:2.104(02/13/2002 15:20)
Serial Number:FGT2002801021023
Operation mode:transparent
Configuring Transparent mode management IP addresses
Login to the CLI if you are not already logged in.
Set the IP address and netmask of the DMZ interface to the Management IP Address and Netmask
that you recorded in
set system interface dmz ip <IP Address> <Netmask>
Example
set system interface dmz ip 10.10.2.2 255.255.255.0
Confirm that the address is correct. Enter:
get system interface
DFL-1000 User's Manual
Transparent mode IP
addresses. Enter:
NAT mode IP
Connecting the DFL-1000 to your network.
addresses.
21

Advertisement

Table of Contents
loading

Table of Contents