Autokey Ipsec Vpn For Remote Clients - D-Link DFL-500 User Manual

Tunnel
Select Incoming NAT if you require Network
Incoming NAT
address translation for VPN packets.
Complete the following procedure on both VPN gateways to add the VPN policy:
·
Go to VPN > IPSEC > Policy .
·
Select New to add a new IPSec VPN policy.
·
Select a Source address.
· Select a Destination address.
· Select the VPN Tunnel Name.
·
Select OK to save the VPN policy.
Example Main office VPN policy

Autokey IPSec VPN for remote clients

Use the following procedures to configure a VPN that allows remote VPN clients with static IP addresses to
connect to users and computers on a main office internal network
network and a remote
static IP address and running VPN client software that uses IPSec and Autokey IKE.
Communication between the remote client and the internal network takes place over an encrypted VPN tunnel
that connects the remote client to the DFL-500 VPN gateway across the Internet. Once connected to the VPN,
the remote client computer seems to be installed on the internal network.
DFL-500 User Manual
configuration).
client). A remote VPN client can be any computer connected to the Internet with a
Select
(See Example VPN between an internal
Select
59