Yamaha YW50P Service Manual page 58

S T E E R I N G A D J U S T M E N T
I INSP
!
S T E E R I N G A D J U S T M E N T
1. Check:
• Steering assembly bearings
Gap the bottom of the forks and gently
rock the fork assembly back and forth.
Loosen-->Adjust.
* * * * * * * * * * * * * * * * * * * * ~ ~ ~ ~ ~ ~ ~ ~ ~ ~ ~ ~ ~ ~ ~ ~ ~ ~ ~
A d j u s t m e n t steps:
• Remove u p p e r cover, l o w e r c o w l i n g , leg
shield 1,2. refer to "COVER AND PANEL" sec-
tion.
• Remove all ringnuts using ringnut wrench.
::~1 Ring nut wrench: I
YU-33975
• Tighten the ring nut 3 (~ using nut wrench.
[~122 Nm(2.2 m.kg, 16 f-t.lb) I
NOTE:
Set the torque wrench to the ring nut w r e n c h
so that they form a right angle.
• Loosen the ring nut 3 (~ 1/4 turn.
• Install rubber ring (~) and ring nut 2 (~, then
tighten the ring nut 2 until it contacts w i t h
rubber ring.
CAUTION:
Aligning the slot of ring nut 2 w i t h the slot of
ring nut 3. If not, slightly t i g h t e n ring nut 2 un-
til the slots a l i g n m e n t .
• Install special w a s h e r (~
NOTE:
Insert the projections of special w a s h e r into the
slots of ring nut 3, 2
• Install ring nut 1 ( ~ r~166Nm(6.6 m.kg, 478~.b> I
• Move the handlebar up and d o w n , and/or
back and forth. If handlebar play is excess,
remove the front fork assembly and check
the balls/ball races. Refer to chapter 6.
3-18