Yamaha YW50P Service Manual page 130

,.o°T B.AKE Ic"AsI ol
/
i
/
I
t
4. Install:
• Pad springs
• Brake pads (new)
Installation steps:
• Connect a suitable hose (~ t i g h t l y to the cali-
per bleed screw (~. Then, place the other end
of this hose into an open container.
• Loosen the caliper bleed screw and push the
piston (~ into the caliper by y o u r finger.
• Tighten the capliper bleed screw.
H ~
~ (0.~
~.k~, 4.3 ~.'~ i
• Install the pad spring (new) and brake pad
(new) (~
• Tighten retaining bolt (~
~ 1 2 3 Nm (2.3 m.kg, 16.6 ft.lb) I
• Install brake hose holder (~
l ~ l 7 Nm (0.7 m.k~, 5.15 ft.lb) I
• Install caliper (~ [~23 Nm (2.3 m.kg, 16.6 ft.ib) I
5. Inspect:
• Brake fluid level
Refer to the "BRAKE FLUID INSPEC-
TION" section in the CHAPTER 3.
(~ "LOWER" level line
6-10