Yamaha YW50P Service Manual page 147

.,,O,EBA, IC"ASI oI
®
®
®
H A N D L E B A R I N S T A L L A T I O N
1. Clean:
• Steering shaft ®
~!~v~v/±1 --'] ~ I I ~ [e-]l
Proper cables and leads routing is essential to
issue safe scooter operation.
2. Install:
• Handlebar O
• Bolt (~)
• Nut I~143Nm(4.3 m.kg, 37ft.lb) I
NOTE:
Match the bolt (~ on to the steering c o l u m n
dent (~.
CAUTION:
There m u s t be a space b after t i g h t i n g bolt ~).
3. Install:
• Ba nd
NOTE:
Clamp the w i r e harness.
4. Apply:
• Lithium soap base grease (to t h r o t t l e
cable end and h a n d l e b a r right end).
6-27
5. Install:
• Handlebar switch (right) (~
NOTE:
Insert the projection (~ into the hole (~ on the
h a n d l e b a r comp.