Yamaha YW50P Service Manual page 117

C A R B U R E T O R
N O T E :
Ic..,I • I
The float arm should be resting on the needle
valve, but not compressing the needle valve.
• If the float height is not w i t h i n specification,
inspect the needle valve, float and valve seat.
• If it is w o r n , replace it.
N O T E :
The float height is properly adjusted at the Yama ha
factory. Never attempt to adjust it.
C A R B U R E T O R A S S E M B L Y
To assemble the carburetor, reverse the disas-
s e m b l y procedures.
Note the f o l l o w i n g points.
CAUTION:
• Before r e a s s e m b l i n g , w a s h all parts in clean
gasoline.
• A l w a y s use a n e w gasket.
5-5