For Safe Operation; Installation Environment And Notes On Cleaning; Notes On Cleaning; Maintenance For Frame Components - MIMAKI JFX series Daily Care Manual

For safe operation

Installation environment and Notes on cleaning

• Use this printer in clean (less dust) environment. The use of fan and ventilator might because of dusty
environment.
They brow dust up dust around the printer.
• As using UV curing ink, install this printer in a well-ventilated area.
• Working environmental temperature is 15 to 30°C (59 to 86°F). Avoid using at lower orhigher than
this.

Notes on cleaning

• Never disassemble the device. Disassembling the device can result in electric shock
hazards and breakage of the device.
• Prevent moisture from entering inside the device. If the inner part of the device becomes
wet, electric shock hazards and breakage of the device can result.
• Conduct maintenance works after turning off the power switch and detaching the power
cable. If not, unexpected troubles can arise.
• Make maintenance after the UV LED has been sufficiently cooled, or burn injury may occur.
• Do not use benzine, thinner and chemical agents containing abrasives. Such materials can
deteriorate or deform the surface of the cover.
• Do not apply lubricating oil or the like inside the device. Such materials can cause the
printer mechanism to fail.
• In case water or alcohol mixed into the organic solvent ink, flocculation would be occurred.
Be sure that not adhere water or alcohol to not only the nozzle and also near the head, the
cap, wiper and so on.

Maintenance for frame components

If the frame components of the device have stained, dampen a piece of soft cloth with water or neutral
detergent diluted with water, squeeze it and wipe the frame components clean.
2
• JFX series is a printer that uses ultraviolet ray curing ink (UV ink).. When
implementing the daily care, must wear supplied goggles and gloves.