Revision Service; Record Of Revisions - AUTO GYRO CAVALON Manufacturer Maintenance Manual

Manufacturer AutoGyro
Maintenance Manual Cavalon
1 – INTRODUCTION
This manual provides accepted and recommended maintenance procedures applicable for the
Cavalon gyroplane, designed and manufactured by AutoGyro GmbH, Hildesheim, Germany. The
generic term "maintenance" comprises checks, inspections, replacement, repair and other tasks,
which are defined in "01-11-00 Definitions and Standard Procedures". The manual also provides a full
description of the aircraft and its systems and troubleshooting (fault isolation) procedures. Where
applicable, the manual refers to related manuals, such as the engine manufacturer's documentation or
Component Maintenance Manuals, for example battery, avionics, or optional equipment.
All task descriptions follow aerospace, industry and safety standards or special AutoGyro procedures.
The procedures, methods, instructions and parameters specified in this manual must be adhered to by
all means. It is not permitted to change procedures or to alter parameters provided herein. Proposed
deviations from the procedures, methods and instructions contained in this manual should be directed
to:
AutoGyro GmbH
Att.: Technical Publications
Dornierstraße 14
31137 Hildesheim
GERMANY
Fax: +49 (0) 51 21 / 8 80 56-19
E-Mail: info@auto-gyro.com
The manual has been prepared in accordance with ATA Specification No. 100 being a common
standard in aviation and for your convenience. The ATA100 numbering system is described under
"Organization and Handling of the Manual".
This manual will be revised as necessary to incorporate changes in design, parts, approved
procedures, or parameters. Note that the manual is only valid if available in current version. The use of
an out dated manual may render the aircraft in unsafe or even not airworthy condition. The revision
service is described below.
Manufacturer Information [Letters] (MI) or Airworthiness Directives (AD) will also be covered by the
revision service and incorporated in the maintenance manual.

Revision Service

This manual must always be maintained in current, up-to-date status. The latest version status is
available at www.auto-gyro.com. Note that the manual is subdivided into 6 parts which will be revised
individually. As an example, the revision index for the manufacturer maintenance manual (MMM),
Cavalon (CV), Part B could be 'MMM-CV-B_13-04-20'. Note that the date code is 'yy-mm-dd' so files
will sort chronologically.
For the purpose of current status this manual will not be published in paper format. A current
personalized copy will be provided by AutoGyro GmbH for all certified and registered service partners
on the basis of a subscription service. Registered users will be informed about new revisions. We
recommend not to keep printouts or paper copies for reference.

Record of Revisions

The manufacturer will keep this manual current as an entire document. After each revision of a part
the latest revision index (i.e. list of revision indices for each part) will be published on AutoGyro's web
portal and/or by E-Mail to each subscription customer. The document part's revision index can be
found in the footer on the left hand side of each page.
Part A – Introduction and Declarations
MMM-CV-A_16-02-08 Page 3 of 12