Assembly: Rotor - Teetering Parts - AUTO GYRO CAVALON Manufacturer Maintenance Manual

62-11-00 4-3

ASSEMBLY: ROTOR - TEETERING PARTS

GENERAL, REFERENCES AND REQUIREMENTS
Basic operational task, which can be performed by a licensed pilot or instructed personnel!
SPECIAL TOOLS AND CONSUMABLE MATERIALS
LR IMPORTANT NOTE: Procedure involves parts with limited reusability. Check parts list below
before starting job!
PRECAUTIONS AND SAFETY MEASURES
WARNING: When handled incorrectly the rotor system can be damaged irreparably. If undetected this
may have catastrophic consequences!
CAUTION: When removing or disassembling make sure to mark all parts so that each and every part of
the component is re-assembled and installed in exactly the same location and orientation!
PROCEDURES
1 The rotor blades (11), clamping profile (10) and rotor hub (7) are each labelled with an engraved serial
number.
2 Insert the first rotor blade carefully into the clamping profile. Make sure that all serial numbers match.
IMPORTANT NOTE: Grease shaft with AG-LUB-03, but do not allow AG-LUB-03 to come into
contact with threads at any time!
3 Fit the rotor hub side with the according serial number to clamping profile (7) and blade (11). Insert 6 x
shoulder bolts (1-5) and corresponding washers (6) without using force so that the bolt end is on top when
the rotor system is installed. For re-identification and correct installation position the shaft length is provided
in the figure above. Example: 40/12 means shaft length 40mm.
4 Position the washers (8) and the self-locking nuts (9) and hand-tighten.
5 Torque-tighten nuts (9) with 15 Nm from the inside to the outside. When doing so, counter-hold bolts (5) to
prevent any damage to the hub and blade holes.
6 Repeat work steps 2 to 5 for the second rotor blade.
7 Check rotor system alignment according to
PARTS LIST
Fig. Pos. Description
1 1 shoulder bolt M8 37/12
1 1-5 M8x60 Rotor blade bolt 8.8 DIN 610
1 2 shoulder bolt M8 40/12
1 3 shoulder bolt M8 43/12
1 4 shoulder bolt M8 46/12
1 5 M8x60 Rotor blade bolt 8.8 DIN 610
1 6 U9/20
1 7 Rotorhub II
1 8 U8
1 9 M8 Si
1 10 Clamping profile blade
MMM-CV-E_16-06-13
Manufacturer
Maintenance Manual
62-11-00 5-1 and adjust, if necessary.
PC PIT
L0 62-00-00-S-33324
L0 62-00-00-V-20661
L0 62-00-00-S-33324
L0 62-00-00-S-33324
L0 62-00-00-S-33324
L0 62-00-00-V-20661
L0 62-00-00-S-33324
L1 01-00-00-V-31793
L0 62-00-00-S-33324
L0 62-00-00-S-33324
L1 01-00-00-V-31793
Part E - 62-11-00 4-3
AutoGyro
Cavalon
OPR
Remark
Page 1 of 2