Tape Protect - Panasonic HD1700pe Operating Instructions Manual

Setup menus
<TAPE PROTECT>
No./Item
400 For selecting the duration of the time taken
after the VTR is left standing in the STOP or
STILL TIMER search STILL mode (JOG, VAR or SHTL)
before the
established.
(Units: s = seconds, min = minutes)
0000 0.5s
0001
0002 10s
0003 20s
0004 30s
0005 40s
0006 50s
0007 1min
0008 2min
401 For selecting the operation to be performed
when the tape protection mode is established
SRC after the VTR has been left standing in the
PROTECT STILL status in a search mode (JOG, VAR or
SHTL).
0000 STEP:
0001 HALF:
0002 T-REL:
<Notes>
• When STEP FWD is selected, the VTR is
automatically transferred to the standby OFF (half-
loading) mode after it has been left standing in the
STILL status for a total of 30 minutes (or 1 minute in
the case of a DV or DVCAM tape).
• When, after tension release has been selected and
the VTR has been transferred to the tension release
mode, the VTR has been left standing in this mode
for a total of 2 hours, it is automatically transferred to
the standby OFF (half-loading) mode. However, in
the case of a DV or DVCAM tape, the transfer to the
tension release mode is inhibited, and the VTR
operates as if STEP FWD has been selected.
402 For selecting whether the drum is to operate
in the standby OFF (half-loading) mode.
DRUM STDBY 0000 OFF:
0001 ON:
<Precaution for STILL TIMER item setting>
The cumulative total standby time passed in the same location
increases at such times when the same material is repeatedly used
as is the case when programs are transmitted, for example.
The underlining (__) denotes the factory setting mode.
90
Description of setting
tape protection mode
5s
<Note>
When a DV or DVCAM tape is
used, the time is set to 10
seconds even when a setting of
2 (10s) or longer is selected.
STEP FWD
Half-loading
Tension release
The drum stops rotating.
The drum continues to rotate.
No./Item
403 For selecting the operation to be performed
when the tape protection mode is established
STOP after the VTR has been left standing in the
is PROTECT STOP mode.
0000
0001
0002
<Notes>
• When STEP FWD is selected, the VTR is
automatically transferred to the standby OFF (half-
loading) mode after it has been left standing in the
STOP mode for a total of 30 minutes (or 1 minute in
the case of a DV or DVCAM tape).
• When, after tension release has been selected and
the VTR has been transferred to the tension release
mode, the VTR has been left standing in this mode
for a total of 2 hours, it is automatically transferred to
the standby OFF (half-loading) mode. However, in
the case of a DV or DVCAM tape, the transfer to the
tension release mode is inhibited, and the VTR
operates as if STEP FWD has been selected.
Description of setting
STEP: STEP FWD
HALF: Half-loading
T-REL: Tension release