Interface; Tape Protect - Panasonic AJ-YA120AG Operating Instructions Manual

Setup menus

INTERFACE

Item
Superimposed
No. No.
display
202 ID SEL
0000
0001
0002

TAPE PROTECT

Item
Superimposed
No. No.
display
400 STILL TIMER 0000
0001
0002
0003
0004
0005
0006
0007
0008
401 SRC PROTECT
0000
0001
402 DRUM STDBY
0000
0001
403 STOP PROTECT
0000
0001
" " indicates the factory setting.
40
Setting
Superimposed
display
For setting the ID information to be returned to the controller.
OTHER 0: The ID information of the VTR other than DVCPRO is set.
DVCPRO 1: The DVCPRO ID information is set.
ORIG 2: Set this only when the unit is connected to a Panasonic controller (such as the
AJ-A900, optional accessory).
<Note>
Select 1 (DVCPRO) or 2 (ORIG) if "23/24," "25(HD)" or "25(SD)" is selected as the
menu item No.25 [SYSTEM FREQ] setting.
Setting
Superimposed
display
0.5S For setting the time to be taken before the unit is set in the tape protection mode
5S when it is left standing in the STOP or STILL status.
10S (Units: S = seconds, min = minutes)
20S <Note>
30S When a DV or DVCAM tape is used, any setting above 2 (10S) will result in a
40S setting time of 10 seconds.
50S
1min
2min
For setting the operation to be performed in the tape protection mode when the unit
is left standing in the STILL status.
STEP 0: STEP FWD
HALF 1: Standby OFF (half loading)
<Note>
If STEP FWD is selected, the unit is automatically transferred to the standby OFF
(half loading) mode when the unit is left standing in the STILL mode for a total of 30
minutes (or 1 minute for DV or DVCAM tape).
For setting the cylinder operation in the standby OFF (half loading) mode.
OFF 0: The cylinder stops rotating.
ON 1: The cylinder continues to rotate.
For setting the operation to be performed in the tape protection mode when the unit
is left standing in the STOP status.
STEP 0: STEP FWD
HALF 1: Standby OFF (half loading)
<Note>
When STEP FWD is selected, the unit is automatically transferred to the standby
OFF (half loading) mode when the unit is left standing in the STOP mode for a total
of 30 minutes (or 1 minute for DV or DVCAM tape).
Description of settings
Description of settings