Panasonic HD1700pe Operating Instructions Manual page 126

RS-232C interface
∫ Commands relating to inquiries
<Notes>
• In terms of the return (completion) message,
[ACK] is returned when data is received, and
only the execution
subsequently returned is listed in the table.
• In the case of commands not listed in the table
below, ER001 (invalid command) is returned
after [ACK].
VTR
Send command
operation
CTL/TC DATA [STX] QCD [ETX]
REQUEST
This command is for inquiring about the counter
value.
data = f w gh mm ss ff
f
w
gh =
With CTL:
With TC:
(525i system)
<Note>
CTL or TC is returned, whichever corresponds to
the front display mode.
STATUS [STX] QOP [ETX]
REQUEST
This command is for inquiring about the VTR's
operation mode.
222 = OEJ:
OFF:
OPL:
ORC: REC
ORW: REWIND
OSP:
SRS:
OBF:
OSF:
OSR:
OJG:
OSW: VAR FORWARD/REVERSE
EAE:
EON:
EPV:
ERV:
ID (VTR No.) [STX] QID [ETX]
REQUEST
This command is for inquiring about the VTR
used.
data = AJ-HD1700
126
message which
Return (completion)
message
4 5 [STX] CD data [ETX]
= F
= S
g = SP(20h): for a plus display
(2Dh): for a minus display
j
h = 0 to 9: hours
gh = 00 to 23: hours
mm = 00 to 59: minutes
ss = 00 to 59: seconds
ff = 00 to 29: frames
4 5 [STX] 222 [ETX]
EJECT
FAST FORWARD
PLAY
STOP (including STANDBY ON)
(IN/OUT) PREROLL
STAND BY OFF
SHTL FORWARD
SHTL REVERSE
JOG FORWARD/REVERSE
AUTO EDIT
EDIT ON (MANUAL EDIT)
PREVIEW
REVIEW
4 5
[STX] data [ETX]
is