Table of Contents
Advertisement
Superimpose screen
The control signals, time code, etc. are displayed on
this screen using abbreviations.
TV monitor
TCR 22 : 22 : 22 : 22
Abbreviations
CTL: Control signal count value
TCR: Time code data recorded in the SBC area
TCR.: Time code data recorded in the VAUX area
UBR: User's bit data recorded in the SBC area
UBR.: User's bit data recorded in the VAUX area
TCG: Time code data of the time code generator
UBG: User's bit data of the time code generator
<Note>
[T 2 R], [T 2 R.], [U 2 R] or [U 2 R.] is displayed when the
data has not been read correctly from the tape.
Characters displayed
The background of the characters superimposed on
the display screen can be changed using
TYPE) on the <TC SHIFT> menu.
TCR 22 : 22 : 22 : 22
TV monitor
<Note>
When the 23/24 Hz mode has been selected as the
system menu item No.25 (SYSTEM FREQ) setting,
the time code and other information superimposed on
the MONITOR and VIDEO OUT3 connectors are not
displayed.
(C
F5
T T C C R R 2 2 2 2 : : 2 2 2 2 : : 2 2 2 2 : : 2 2 2 2
TV monitor
Display position
The position of the characters superimposed on the
display can be changed using
(C VPOS) on the <TC SHIFT> menu and the ADJ
dial.
TCR 22 : 22 : 22 : 22
TV monitor
Operation mode
The VTR's operation mode can also be displayed
using
(DISPLY) on the <TC SHIFT> menu.
F4
TCR 22 : 22 : 22 : 22
STOP
TV monitor
(C HPOS) and
F2
F3
TCR 22 : 22 : 22 : 22
TV monitor
VTR operation mode
113
Advertisement
Table of Contents
