Safety Precautions - Sanyo MLS-3751 Instruction Manual

Safety Precautions

• Read these
Safety Precautions
• Be sure to observe the precautions without fail as they are intended to ensure the safe use of the product, protect
you and other people against hazards, and prevent loss of and damage to property.
The indications and meanings of each category of precaution are as shown below.
• The possible consequences due to inobservance of these precautionary indications or inappropriate operation of
the product are classified into the 3 categories as follows.
DANGER : This warns of actions that will cause death or serious injury to the operator or other persons.
WARNING : This warns of actions that could possibly cause death or serious injury to the operator or other
persons.
CAUTION : This warns of actions that are likely to cause injury to the operator or other persons or loss of
damage to the property.
• The symbols appearing in the text mean the following.
This symbol denotes a
prohibited action that
must not be performed.
This symbol denotes a
compulsory action that must
be performed without fail.
• The labels appearing in the text mean the following.
denotes a caution to be observe.
Never introduce inflammables in the product.
Do not put the following substances specified in Annex
1 of the Occupational Safety and Health Act Enforcement
Ordinance into or near the product.
• Explosive substances
• Flammable substances
Failure to observe this warning may result in injury, fire or trouble with the product by possible explosion.
Do not put anything that corrodes
stainless steel inside the product.
Do not put culture mediums that corrodes
stainless steel inside the product.
Failure to observe this warning may result in injury,
fire or trouble with the product by possible explosion.
1
carefully before use so as to use the product properly.
General prohibition
Contact with water prohibited
You must do this.
This part is hot and may burn.
DANGER
• Ignitable substances
• Combustible substances
WARNING
These precautions must be
observed without fail.
Disassembly
prohibited
Grounding wire must be connected.
• Oxidizing substances
Check the cover packings.
Sterilization of animal oil and fat (e.g., waste generated
after BSE inspection) causes premature wear, cracking
or breakage of the cover packings. If the product is used
with defective packings, steam may escape and cause
burns or other accidents.
or:
Touching with wet
hands prohibited