Sanyo MLS-3751 Instruction Manual page 31

Daily Inspection
Check the cover packing for any crack or flaw. If any crack or flaw is found, immediately stop use of the product
and ask your dealer for replacement.
Check the cover packing
Sterilization of animal oil and fat (e.g.,wastes generated after BSE inspection) causes premature
wear, crack or breakage of the cover packings. If the product is used with defective packings,
steam may burst out resulting in burn and other accidents.
Safety Inspection
This product incorporates the inspection display circuit.
This circuit is to display the time to ask your dealer for inspection when the product is used in a
certain number of times.
(As for details about inspection including cost, etc., please consult the dealer from whom you
purchased the product.)
Operation of the inspection display is as follows:
• The frequency of use of this product reaches the preset number of times,
flickers on the digital display and at the same time the buzzer sounds to tell that the time for safety
inspection comes when the power switch is set to ON. At this moment, it is impossible to operate
other buttons than the stop button.
• To delete the inspection display temporarily, press the
the inspection display appears again. This condition will go on unless the safety inspection is
implemented.
Ask your dealer for the safety inspection ahead of time.
If something unusual should happen during operation
Stop using the unit immediately, and ask your dealer to inspect and repair it. It is dangerous for the
customer to attempt to disassemble and repair the unit. Special technology is required for repair.
Questions concerning after-sales service
Direct any questions or queries concerning repair service or the unit itself to your dealer or to the
manufacturer's customer service representative.
WARNING
button. However, in the standby status,
appears and
30