Sanyo MLS-3751 Instruction Manual page 7

Do not wet the product.
Failure to observe this caution may cause short-circuits
in live parts, resulting in electric shock or fire.
Install the product on a level surface.
Anchor the product firmly with the tip-resistant
metal attached to the product.
If the product is installed on an inclined surface, hot
water in the chamber will spill, resulting in scald or
electric shock.Moreover, the product may fall, resulting
in injury or damage to the floor.
Hold the grips when moving the product.
Unlock the casters when moving the product.
Accidentally dropping the product may result in injury
CAUTION
Drain off heating water everyday after
use of the product.
Insert the attached drain hose in the drain water
port and drain water at least 2 hours after operation.
If water is drained out in haste, hot water may splatter,
resulting in burns or damage to the floor.Repeated use
of the same heating water may corrode the chamber or
clog the piping.
Do not move the product with the
exhaust tank full of water.
Tip-resistant
metal
When moving the product, be sure to discard water
in the exhaust tank.
Failure to observe this caution may cause hot water to
spill from the exhaust tank, resulting in burns or accident.
If trouble is indicated on the process
display, set the power switch in the
OFF
OFF
If the same condition persists even after retrying
the operation, set the power switch in the
position, shut down the main power, and contact
the dealer from whom you purchased the product.
Continuing to operate the product anything but proper
working order may result in electric shock or fire.
position.
Set power
switch to OFF.
OFF
6