Table of Contents
Advertisement
Setup Menus
OPERATION menu
Item
Superimposed
No.
display
100
SEARCH SPEED
101
SHTL MAX
102
FF. REW MAX
105
STOP MODE
106
HUMID OPE
107
WIDE MODE
110
AUTO BACK
111
AFTER CUE-UP
113
BATTERY SEL
The underlining indicates the factory setting.
Setting
Superimposed
No.
display
For setting the speed at which the tape is to be decelerated when the
search switch on the front panel has been pressed.
0000
X4.1
0: 4.1a normal tape speed
0001
X8.4
1: 8.4a normal tape speed
For setting the maximum speed in the shuttle mode when the external
controller connected to the 9-pin remote connector is used.
0000
X8.4
0: 8.4a normal tape speed
0001
X16
1: 16a normal tape speed
2: 32a normal tape speed
0002
X32
For setting the maximum fast forward and rewind speed.
0000
X16
1: 16a normal tape speed
0001
X32
2: 32a normal tape speed
0002
X60
3: 60a normal tape speed
<Note>
When the 50 Mbps mode has been selected as the menu item No. 007
(SYS FORMAT) setting, the tape will run at 32a the normal tape speed
even if 60a has been selected.
For setting the mode of the digital circuit in the stop mode.
0000
REC
0: The digital circuit serves as the REC circuit. It takes a shorter time for
operation to transfer to the REC mode.
At this point, the E-E mode is established.
0001
PB
1: The digital circuit serves as the PB circuit. It takes a shorter time for
operation to transfer to the playback mode.
For setting whether to ignore condensation when it has formed and
continue with operation.
0000
OFF
0: Unit does not continue to operate when condensation has formed.
0001
ON
1: Unit continues to operate when condensation has formed, in which case
it cannot be guaranteed that the unit will operate normally.
<Note>
Since the tape may be damaged with a "1" setting, this item should normally
be set to 0 (no operation).
For setting whether to perform recording in the wide mode.
0000
WIDE
0: Recording is performed in the wide mode.
0001
NORMAL
1: Recording is performed in the 4:3 normal mode.
For setting the operation method of the frame-to-frame continuity function
(for setting the operation of the auto back function for rewinding the tape for
several seconds in order to eliminate disturbances in the recorded pictures).
0000
OFF
0: Auto back function is disabled (no continuity between frames).
0001
REC-P
1: In the REC PAUSE mode, the auto back function is activated to ensure
frame-to-frame continuity.
0002
ALL
2: Regardless of the VTR mode, the auto back function is activated to
ensure frame-to-frame continuity.
For setting the status after cue-up.
0000
STOP
0: For stopping the tape in the stop mode.
0001
STILL
1: For stopping the tape in the still mode.
For setting the type of battery.
0000
BP402
0: AU-BP402 (made by Matsushita Electric Industrial), 12 V nickel-cadmium
battery
0001
BPH90
1: BP-H90 (made by IDX), 12 V nickel-hydrogen battery
0002
BPH100
2: BP-H10C (made by IDX), 13 V nickel-hydrogen battery
0003
HP90
3: HP-H90 (made by PACO), 13 V nickel-hydrogen battery
0004
HP90A
4: HP-H90A (made by PACO), 13 V nickel-hydrogen battery
46
Description of setting
Advertisement
Table of Contents
