Operation Menu - Panasonic AJ-HD150 Operating Instructions Manual

Setup menus
USER menu
<OPERATION>
No.
107
108
109
110
111
The underline on the setting item denotes the initial setting.
Memory stop function
! When the FF button is pressed, the VTR performs the regular fast forward operation since the zero point is not located in the
direction of operation.
@ When the REW button is pressed, the PREROLL lamp lights (the SHTL lamp lights as well), the VTR proceeds with the
preroll operation, and it automatically stops when it reaches the position where the counter reads "0."
# When the REW button is pressed, the VTR performs the regular rewinding operation since the zero point is not located in the
direction of operation.
$ When the FF button is pressed, the PREROLL lamp lights (the SHTL lamp lights as well), the VTR proceeds with the preroll
operation, and it automatically stops when it reaches the position where the counter reads "0."
(continued)
Item Setting
Superimposed Superimposed
No.
display display
EE MODE 0000 NORMAL
SEL 0001
PLAY 0000
:
DELAY
0015
CAP.LOCK 0000
0001
AUTO REW 0000
0001
MEMORY 0000
STOP 0001
FWD direction
3 REW button
4 FF button
– 57 –
This selects the EE mode output signals.
0: Signals are output with a delay equivalent to the length of
THRU
internal signal processing.
1: Signals are output directly, without internal processing, and
so are output with no delay.
<Note>
When editing mode is selected, SDTI is selected as the video
input signal (when the optional board AJ-UDC150P has been
installed), or INT SG is selected at either VIDEO or AUDIO, he
internal operations are forcibly set to NORMAL.
0 This set the play delay time in frame increments.
:
15
This selects whether the playback framing is to be locked in 4-
2F
field or 2-field increments.
4F
0: 2F mode
1: 4F mode
OFF This selects whether to rewind the tape automatically to the
ON tape start when the tape end is detected.
0: The tape stops at the tape end.
1: The tape is rewound to the tape start.
This selects whether the VTR is to stop automatically when
OFF
the counter value reaches "0" during a fast forwarding or
ON
rewinding operation in the CTL mode.
0: The VTR does not stop.
1: The VTR stops automatically.
<Notes>
1. The stop mode concerned is either the stop or the still-
picture (SHTL STILL) mode depending on the setup menu
No. 315 (AFTER CUE-UP) setting.
2. When both the AUTO REW function and MEMORY function
have been selected at the same time, the AUTO REW
function takes precedence.
The MEMORY STOP function does not work if it is
activated within a range of 0 2 frames.
Zero
point
1 FF button
2 REW button
Description