Superimposed Screens - Panasonic AJ-D92P Operating Instructions Manual

Superimposed Screens

When the unit's VIDEO OUT 2 connector has been
connected to a TV monitor, the control signals, time
codes, etc. can be displayed as abbreviations on the
TV monitor screen.
This display can be set to ON or OFF using the
SUPER IMPOSE switch.
TV monitor
Abbreviations
CTL (control signal)
TCG (time code generator value)
TCR (playback value of time code)
UBG (user's bit generator value)
UBR (playback value of user's bit)
<Notes>
O The colon between the seconds and frames
changes to a period when a drop frame time code
is being read. The same time code also appears
on the status display window, and the operating
status display "DF" is indicated.
O When the time code signal is missing, it is
automatically interpolated by the CTL signal.
The following appears on the display.
T R 00 : 07 : 04 : 24
The colon between the seconds and frames
changes to a period when a drop frame is
read.
An asterisk ( ) appears when the
time code signal is missing.
(For superimposing only)
No display:
Normally, no display.
P: Flashes when the DC
supply voltage has
dropped.
L: Flashes in "LOW RF"
status.
N: Flashes in "NO RF"
status.
38
Display characters
The background of the superimposed display
characters can be changed by setting setup menu
item No. 006 (CHARA TYPE).
(See page 45)
TV monitor
Display position
The position of the superimposed display can be
changed by setting setup menu items No. 004
(CHARA H-POS) and No. 005 (CHARA-V.POS).
(See page 45)
TV monitor
<Notes>
When the PAGE button and DATA+ button or DATA–
button are pressed, the counter display appears
temporarily on the TV monitor while these buttons are
held down to enable the setting to be checked.
Even while the PAGE button is pressed, the settings
can be performed using the DATA+ button or DATA–
button while the actual status is checked.
TV monitor
TV monitor