Shut Down And Clean-Up; Storage - Shark DE-2010 Operating Instructions Manual

STEP 1: Remove de-
tergent suction tube
from container and in-
sert into one gallon of
fresh water. Slide
nozzle forward for low
pressure or to connect
black detergent
nozzle. Pull trigger on
spray gun and siphon
water for one minute.
Pump
Water
Inlet
STEP 5: Disconnect the garden
hose from the water inlet on the
machine.
Pump Storage
CAUTION: Always store your pres-
sure washer in a location where the
temperature will not fall below 32° F
(0° C). The pump in this machine is
susceptible to permanent damage if
CAUTION
frozen.
FREEZE DAMAGE IS NOT COVERED
BY WARRANTY.
If you must store your pressure washer in a location
where the temperature is below 32° F, you can mini-
mize the chance of damage to your machine by drain-
ing your machine as follows:
1. Stop the pressure washer and detach supply hose
and high pressure hose. Squeeze the trigger of the
spray gun to drain all water from the wand and
hose.
2. Restart pressure washer and let it run briefly (about
5 seconds) until water no longer discharges from
the high pressure outlet.
SHUTTING DOWN AND CLEAN-UP
On/Off
Switch
STEP 2: Turn off machine by
flipping switch on rear of mo-
tor.
STEP 6: Disconnect the high
pressure hose from high pres-
sure outlet.

STORAGE

96-720, 97-708, 97-709, 97-710 • REV. 2/04
STEP 3: Turn off water supply.
High
Pressure
Outlet
Safety
Latch
STEP 7: Engage
the spray gun
safety lock.
STEP 4: Press trigger
to release water pres-
sure.
9