Kärcher BR/BD45/40C Bp Original Instructions Manual page 34

the cleaning program. The settings are
done using the Info button.
Operator menu
Release emergency-stop button by
turning.
Set main switch to "1".
BR/BD...C...: Turn the program selec-
tion switch to the desired cleaning pro-
gram (1...5).
BR/BD... W...: Set the traction switch to
"1" or programme selection switch to
the desired cleaning programme (1...6).
The display shows the battery charging
status.
Select the desired parameter by turning
the Info button. The currently set value
is displayed.
Press Info button, the value/ bar flashes.
Reset the parameter by turning the Info
button between "min" and "max".
Confirm the changed setting by press-
ing the Info button or wait till the set val-
ue is automatically accepted after 10
seconds.
Note
If the selected parameter does not change
within 10 seconds, then the display goes
back to displaying the battery charging sta-
tus.
The cleaning parameters can be set and
are applicable to all programmes.
All settings are saved even in the power-
less state of the machine.
Reset parameters
Set cleaning programme wet scrubbing,
suction, polishing, scrubbing or polish
suction using the programme selection
switch.
Select the menu item "Factory setting"
in the operator menu by turning the Info
button
Press Info button. The factory settings
of all parameters are restored for each
cleaning program.
34
Adjustable pa-
rameters
Detergent dos-
ing (DOSE)
Only BR...:
FACT*) (brush
speed)
Cleanspeed
*) The cleaning performance can be set in
3 stages:
Fine Clean: Lower brush speed for re-
–
moving the grey film on fine stone
floors.
Whisper Clean: Medium brush speed
–
for regular cleaning with reduced noise
level.
Power Clean: High brush speed for pol-
–
ishing, crystallising and sweeping.
Factory setting
The table given below gives details of the
factory settings of the parameters for the
cleaning programs. If no values are en-
tered, then the respective parameter can-
not be set in the given cleaning program.
Scrubbing suction 1
Wet scrubbing
Dry vacuum clean-
ing
Polishing
Polish suction
Driving
*) Only BR...: P=Power Clean
10
-
EN
min:step:m Remark
ax
0,5% : 0,5% Ideal deter-
: 3% gent con-
centration
– Power
Clean,
Whisper
Clean, Fine
Clean
0 : 1 : 5 Driving
speed
3
–
–
p
–
p
–