Configuring the Ethernet CP with STEP 7
3.3 Setting further CP properties
Table 3- 2
Object properties of the interface (Ethernet/gigabit and PROFINET)
Parameter group / function
Networking Ethernet CP (Page 40)
Networking the interface
"Port parameters" parameter group (Page 61)
Interface (port properties)
Individual network settings / transmission
rate / duplex *)
"Options / Settings" parameter group (Page 46)
Communications interrupts
"IP configuration" parameter group (Page 55)
Configuration of the IP address
•
setting
Configuration method for configuring
•
IP address
"PROFINET" parameter group (Page 63)
Set properties for PROFINET IO and
PROFINET CBA
I device
Configure device as intelligent
PROFINET IO device
Synchronization
Configuring synchronization properties of
the device as a PROFINET IO controller
Media redundancy (Page 70)
Configuring the device as a node in a
ring topology with the media redundancy
method MRP
3.3.2
"General" parameter group
Function of the I&M data
Among other things, in this area, you can configure identification data for modules that
support I&M data (I&M = Identification & Maintenance). These are the plant designation and
the location designation. With the I&M data, for example, standardized identification systems
for devices are supported in the power station sector. Regardless of this, you can use the
I&M data for an additional device identifier you require.
44
STEP 7 V5.5
Tabs in the "Object
properties" dialog of the
interface
> General
> Options
> Options
> IP configuration
PROFINET interface >
PROFINET
PROFINET interface > I
device
PROFINET interface >
synchronization
PROFINET interface >
media redundancy
Configuring and commissioning S7 CPs for Industrial Ethernet
Configuration Manual, 09/2013, C79000-G8976-C182-13
STEP 7 Professional
Parameter group under
"Properties > General"
> ...Interface
> Interface networked with
> Advanced options
> Settings
> IP protocol
PROFINET interface
PROFINET interface > I
device
PROFINET interface >
synchronization
PROFINET interface >
Advanced options > Media
redundancy