Setting Further Cp Properties; Overview - Siemens S7-300 Configuration Manual

Configuring the Ethernet CP with STEP 7

3.3 Setting further CP properties

3.3 Setting further CP properties
3.3.1

Overview

In addition to the network connection, you can also make other module-specific settings or
call up functions.
The following lists show you an overview of the additional parameters that can be set or
functions that can be called. With both product variants of STEP 7, you will receive
information about where these parameters or functions are available. The following sections
contain detailed information.
The parameters are assigned according to the following criteria:
● Object properties of the device
● Object properties of the interface (Ethernet/gigabit and PROFINET)
The following lists are structured accordingly
Table 3- 1 Object properties of the device
Parameter group / function
Networking Ethernet CP (Page 40)
Module name
Plant designation, location
identifier
Parameter / function "Module addresses" (Page 45)
Interface parameters for the
user program
"Options / Settings" parameter group (Page 46)
Module access protection
(protection level)
Module replacement without a
PG (S7-300)
Ethernet profile for faulttolerant
connections
Sending keepalives for
connections
Multiplex OP connections /
Occupy internal CPU connection
resource
UDP buffering
File system (case-sensitive)
"Time-of-day synchronization" parameter group - mode (Page 50)
42
STEP 7 V5.5
Tabs in the "Object properties"
dialog of the device
> General
> General
> Addresses
Options / settings
Options / settings
Options / settings
Options / settings
Options / settings
Options / settings
Options / settings
*)
Configuring and commissioning S7 CPs for Industrial Ethernet
Configuration Manual, 09/2013, C79000-G8976-C182-13
STEP 7 Professional
Parameter group under
"Properties > General"
> General
> Identification & Maintenance
> I/O addresses
Customize
Customize
Customize
PROFINET interface > Interface
options
Customize
Customize
Customize