Module Status / Rack Configuration - Siemens S7-300 Configuration Manual

Parameter
Date
Event (language
switchover not
possible)
Details with "number"
(information in an
additional tab at the
end of the table)
Event ID
Event ID
11.3.4

Module status / rack configuration

Note
Module type
Depending on the module type used for Web diagnostics, the number and arrangement of
the parameters may differ from the following description. The meaning of the parameters is
unaffected.
Configuring and commissioning S7 CPs for Industrial Ethernet
Configuration Manual, 09/2013, C79000-G8976-C182-13
Function
Date on which the event occurred.
Note
If there is no time-of-day/date synchronization, 01.01.1984 is taken as the default date for the
module startup
Display of the diagnostics buffer entry in plain language.
The display is made in the language specified by the loaded text file. When the CP ships, the
English language file is loaded as default.
The "Language switchover not possible" information indicates that the language file used for the
diagnostics buffer texts is not dependent on the language setting for Web diagnostics.
For information on downloading the language file, refer to the section Update center (Page 194).
For Advanced CPs, the downloading of the language file using FTP is also described.
Note: If text entries are missing for some events, reloading a language file may remedy the
situation.
The number identifies the entry in the list.
Depending on the module type, additional information about the diagnostics event can appear
here.
Note that there may be additional information on the entries. You can reach these additional help
texts via the display of the diagnostics buffer in STEP 7 special diagnostics.
Event ID of the diagnostics buffer entry
Web diagnostics
11.3 Diagnostics pages of the CP
175