Communications Processors For S7400 - Siemens S7-300 Configuration Manual

Characteristics of the Ethernet CPs

2.2 Communications processors for S7400

2.2 Communications processors for S7400
The module was designed to match the components of the S7400 / S7400H automation
system and has the following features:
● Singlewidth module for simple installation in the S7400 / S7400H rack
● Can be used in central or expansion racks.
● The operator controls and displays are all located on the front panel.
● No fan necessary
● Interfaces: depending on the device type
● The configuration of the CP is possible over MPI or LAN/Industrial Ethernet. The version
of STEP 7 must be released for the device type necessary.
Figure 2-1
34
Legend:
1 X = Placeholder for hardware version
2 CPLUG (at rear)
3 Firmware version
4 LEDs
5 Gigabit interface: 1 x 8pin RJ45 jack / security: External
6 PROFINET interface: 4 x 8pin RJ45 jack
7 Label with MAC addresses
Example of an S7-400 CP: CP 443-1 Advanced
Configuring and commissioning S7 CPs for Industrial Ethernet
Configuration Manual, 09/2013, C79000-G8976-C182-13