Firmware Information - D-Link dxs-3350sr Installation & User Manual

open the Firmware Information link. The default setting for the Switch's firmware will have the boot up firmware stored
in Image 1, but the user may set either firmware stored to be the boot up firmware by using the Config Firmware Image
window.

Firmware Information

The following window allows the user to view information about current firmware images stored on the Switch. To access
the following window, click Maintenance > Multiple Image Services > Firmware Information.
This window holds the following information:
Parameter
BOX
ID
Version
Size
Update Time
From
User
DXS-3350SR Gigabit Layer 3 Switch
Figure 8- 3 . Firmware Information window 7
Description
States the stacking ID number of the switch in the switch stack.
States the image ID number of the firmware in the Switch's memory. The Switch can
store 2 firmware images for use. Image ID 1 will be the default boot up firmware for
the Switch unless otherwise configured by the user.
States the firmware version.
States the size of the corresponding firmware, in bytes.
States the specific time the firmware version was downloaded to the Switch.
States the IP address of the origin of the firmware. There are four ways firmware may
be downloaded to the Switch.
R – If the IP address has this letter attached to it, it denotes a firmware upgrade
through the Console Serial Port (RS-232).
T - If the IP address has this letter attached to it, it denotes a firmware upgrade
through Telnet.
S - If the IP address has this letter attached to it, it denotes a firmware upgrade
through the Simple Network Management Protocol (SNMP).
W - If the IP address has this letter attached to it, it denotes a firmware upgrade
through the web-based amangement interface.
States the user who downloaded the firmware. This field may read "Anonymous" or
"Unknown" for users that are not identified.
245