D-Link dxs-3350sr Installation & User Manual page 197

Configure the following parameters to add an Authentication Server Host:
Parameter Description
IP Address
Protocol
Port(1-65535)
Timeout(1-255)
Retransmit(1-255)
Key
Click Apply to add the server host.
DXS-3350SR Gigabit Layer 3 Switch
The IP address of the remote server host the user wishes to add.
The protocol used by the server host. The user may choose one of the following:
TACACS - Enter this parameter if the server host utilizes the TACACS protocol.
XTACACS - Enter this parameter if the server host utilizes the XTACACS protocol.
TACACS+ - Enter this parameter if the server host utilizes the TACACS+ protocol.
RADIUS - Enter this parameter if the server host utilizes the RADIUS protocol.
Enter a number between 1 and 65535 to define the virtual port number of the
authentication protocol on a server host. The default port number is 49 for
TACACS/XTACACS/TACACS+ servers and 1813 for RADIUS servers but the user
may set a unique port number for higher security.
Enter the time in seconds the Switch will wait for the server host to reply to an
authentication request. The default value is 5 seconds.
Enter the value in the retransmit field to change how many times the device will
resend an authentication request when the TACACS server does not respond.
Authentication key to be shared with a configured TACACS+ or RADIUS servers only.
Specify an alphanumeric string up to 254 characters.
NOTE: More than one authentication protocol can be run on the same
physical server host but, remember that TACACS/XTACACS/TACACS+
are separate entities and are not compatible with each other
188