D-Link dxs-3350sr Installation & User Manual page 213

The following parameters are displayed:
Parameter Description
User Name
Group Name
SNMP Version
Auth-Protocol
Priv-Protocol
To return to the SNMP User Table, click the
To add a new entry to the SNMP User Table Configuration, click on the Add button on the SNMP User Table page.
This will open the SNMP User Table Configuration page, as shown below.
DXS-3350SR Gigabit Layer 3 Switch
An alphanumeric string of up to 32 characters. This is used to identify the SNMP
users.
This name is used to specify the SNMP group created can request SNMP messages.
V1 - Indicates that SNMP version 1 is in use.
V2 - Indicates that SNMP version 2 is in use.
V3 - Indicates that SNMP version 3 is in use.
None - Indicates that no authorization protocol is in use.
MD5 - Indicates that the HMAC-MD5-96 authentication level will be used.
SHA - Indicates that the HMAC-SHA authentication protocol will be used.
None - Indicates that no authorization protocol is in use.
DES - Indicates that DES 56-bit encryption is in use based on the CBC-DES (DES-
56) standard.
Show All SNMP User Table Entries
Figure 7- 28. SNMP User Table Configuration
link.
204