Table of Contents
Advertisement
MCAC-RTSM-201301-01
Assemblies on the installation site
5-core shielded cable
Switch box
Wiring Tube (Insulating
sleeve and tightening screw)
Installation procedure
※ Circuit of wired controller is low voltage circuit. Never connect it with a standard 220V/380V
circuit or put it into a same wiring tube with the circuit.
※ The shield cable must be connected stable to the ground, or transmission may fail.
※ Do not attempt to extend the shield cable by cutting, if it is necessary, use terminal
connection block to connect.
※ Wired controller installation size refers to the following picture (Unit: mm):
※ Turn a screwdriver at the concave on bottom panel of the wired controller to remove the
back cover.
Name
Quantity
Embedded
Embedded
into wall
onto wall
1
1
1
\
1
\
Midea R22 T1 side-discharge duct manual
Remarks
2
Take 0.05mm
×5 cable below
15m length.
\
\
75
Hide quick links:
Advertisement
Table of Contents
