Operating The Remote Controller - Midea MTA1-76HR Technical Manual

MCAC-RTSM-201301-01
display.
④ TIMER Display: This display area shows the settings of TIMER.
That is, if only the starting time of operation is set, it will display the TIMER ON. If only the turning off
time of operation is set, it will display the TIMER OFF. If both operations are set, it will show TIMER
ON and TIMER OFF which indicates you have chosen to set both the starting time and off time.
⑤ FAN Display: When push the FAN button, this indicator lights.
⑥ Digital Display Area: This area will show the temperature and, if in the TIMER mode, will show
the ON and OFF settings of the TIMER.
Notes:
All items are shown in the Fig-2 for the purpose of clear presentation but during the actual operation only the relative
functional items are shown on the display panel.

8.4 Operating the remote controller

1) Install / Replace Batteries
The Remote Controller uses two alkaline dry batteries (R03/Ir03X2).
※ To install batteries, slide back the cover of the battery compartment and install the batteries
according to the directions (+and -) shown on the Remote Controller.
※ To replace the old batteries, use the same method as mentioned above.
Notes:
1. When replacing batteries do not use old batteries or a different type battery. This may cause the remote
controller to malfunction.
2. If you do not use the remote controller for several weeks remove the batteries. Otherwise battery leakage
may damage the remote controller.
3. The average battery life under normal use is about 6 months.
4. Replace the batteries when there is no answering beep from the indoor unit or if the Transmission Indicator
light fails to appear.
2) Automatic Operation
When the Air Conditioner is ready for use, switch on the power and the OPERATION indicator lamp
Midea R22 T1 side-discharge duct manual
63