Midea MTA1-76HR Technical Manual page 80

MCAC-RTSM-201301-01
⑦
ON/OFF button: Push the button at the condition of off, the OPERATION lamp lights, and the
wired controller enter in to on operation, simultaneously sends the information of operation mode set
currently, temperature, fan speed, timer, etc. Push the button at the condition of on, the OPERATION
lamp extinguishes, simultaneously sends the off. If having set timer on or timer off, the wired
controller will cancel these settings before entering into off, close the concern indicator, and then
send the off information.
⑧
FAN SPEED button: Select any one fan speed from 'AUTO', 'LOW', 'MED' and 'HIGH'. Each
time push the button, the fan speed will change in turn as following:
⑨
TEMP ▲ button: Set indoor temperature up. If press and hold on, it will increase at 1 degree
per 0.5 second.
⑩
TEMP ▼ button: Set indoor temperature down. If press and hold on, it will decrease at 1 degree
per 0.5 second.
⑪
SWING button: Push this button for the first time when operation, it will start the swing function.
Push the button for the second time, cancel the swing function.
Note: The function is available matched with the concerned unit.
⑫
ECONOMICAL button: Push the button to set the economical operation mode for air conditioner,
push again then cancel the mode. The operation mode is suitable for sleeping time.
⑬
COOL / HEAT button (Hidden): Use a small stick with a diameter of 1mm to push the button to
switch modes. For cooling only type, it will be no heating mode when pressing MODE. The uniform
mode is cooling and heating at the factory.
⑭
LOCK button (Hidden): Use a small stick with the diameter of 1mm to push the LOCK button to
lock the current setting, push the button again, then cancel the setting.
Midea R22 T1 side-discharge duct manual
69