BORETTI BPK-45 Operating Instructions Manual page 14

9. DISPENSING HOT WATER
To dispense hot water, suitably position the water/steam
nozzles, see Fig. 10.1
GB
• Position a container below the water/steam nozzle.
• Press the hot water button.
• Press the START button with 10 seconds from
making your selection. The water will be dispensed
as long as the button is pressed; to stop dispensing,
release the button.
ATTENTION: if the start button is not pressed
within 10 seconds, the function is disabled. If
you wish to dispense a beverage, you will have
to repeat the procedure.
We recommend that you do not dispense hot
water immediately after dispensing steam.
10. DISPENSING STEAM
To dispense steam, press the steam button. The
corresponding indicator light will flash for 15 seconds.
As soon as the indicator light stops flashing and remains
steady on, the machine is ready to dispense steam.
• Place the container with the liquid to be heated below
the steam nozzle.
• Completely immerse the nozzle in the liquid to be
heated.
• Press the START button within 10 seconds from
making your selection and wait for the steam to come
out.
ATTENTION: if the start button is not pressed
within 10 seconds, the function is disabled. If
you wish to dispense a beverage, you will have
to repeat the procedure.
The steam will continue to flow until you release the
START button.
If you are preparing milk for a cappuccino, we
suggest that you agitate the
milk container for better results.
11. PROGRAMMING THE qUANTITY OF
GROUND COFFEE
You can choose from three strengths of coffee:
• light;
• medium;
• strong.
To change from one type of coffee to the other, just
press the button as shown in Fig. 12.1. The LED for the
selected coffee will light (in Fig. 12.2, light coffee).
26
FOR EXPERT USERS ONLY:
PROGRAMMING THE GRINDING TIME
The grinding time for strong coffee is programmable and
medium and light coffee are calibrated accordingly.
To enter programming mode, when the machine is in
standby mode:
• press the START/STOP button for 5 seconds; the
LED s on the upper left line light up to indicate the
grinding time;
• to increase the time, press the coffee regulation
button and to, decrease it, the START/STOP button.
At the end of the operation, just press the on/off
button to exit and confirm the changes.
12. PROGRAMMING THE qUANTITY OF
COFFEE IN THE CUP
All the cycles have a preset quantity, except for water
and steam.
The machine is already calibrated at the factory to
dispense the ideal quantity of coffee for an espresso
cup.
While dispensing the beverage, you can stop dispensing
before the preset time by pressing the START/STOP
button.
In addition, while dispensing the beverage, you can
obtain a greater quantity than the preset by holding
down the START key continuously within 3 seconds
from the end. This activates the dispensing of additional
beverage until the button is released, up to a maximum
of 20 seconds.
The procedure for programming the quantity of coffee,
and other beverages, in the cup is as follows:
• press the coffee key for 5 seconds until the LED
flashes.
• press the START/STOP key to start dispensing. The
two LEDs flash for its duration.
• press the START/STOP button again when the
desired quantity is reached.
Restoring the factory settings
When it leaves the factory, the machine is calibrated
for Italian-style espresso coffee and German-style
stretched coffee.
• If you need to restore these standard values, you
must place the machine in standby and press the
coffee regulation button for 6 seconds.
• You will see all the LEDs, except on/off, flash for 5
seconds; after that time, the board has stored the
default values.
• Press the on button and the selections will now use
the factory values.
The standard values are only relative to the
quantity of water necessary for each single
dose.
27
EN