Panasonic KX-TVS50 Installation Manual page 243

Parameter
Paging Code
for Group 1-8
Paging Code
for All Groups
Other Parameters - Fax Management
The VPS can be programmed to automatically transfer incoming fax calls to a fax extension.
A maximum of 2 fax extensions can be specified as the destination for the Automatic Fax
Transfer. If the main fax extension is not available to receive a fax, the VPS will transfer the
fax transmission to the alternate fax extension.
To select Fax Management, follow the menu path as shown:
System Administration Top Menu - 1 - 5 - 7 - 8
Parameter
Automatic
Transfer of
Incoming Fax
Call
Main Fax
Extension No.
Alternate Fax
Extension No.
SYSTEM ADMINISTRATOR'S GUIDE
B6 SYSTEM ADMINISTRATION - SYSTEM PARAMETER SETTINGS
Table 60
Value Range
(Default)
Up to 12 digits Specifies the intercom paging access code required by
consisting of the PBX.
0-9, ,# for each
group
Note: The Intercom Paging Group Number available
(Group 1-8:
for each Subscriber is determined on a COS-by-COS
331-338
basis.
All Groups
(Group 9): 33 )
Table 61
Value Range
(Default)
1: Disable Used to enable or disable the Automatic Transfer of
2: Enable Incoming Fax Call Service.
(Disable)
Note: Automatic detection works for only the first 30s.
2-5 digits Specifies the main fax extension number.
(None)
2-5 digits Specifies the backup fax extension number used when the
(None) main fax extension is busy or if there is no answer within
the specified "Fax No Answer Time." When either of
these situations occurs, the VPS transfers the fax call to
the backup extension.
Description/Function
Description/Function
243