Circuit Condition Display (Lmon); Dtmf Information Display (Putd) - Panasonic KX-TVS50 Installation Manual

7.2 UTILITY COMMANDS

7.2.18 Circuit Condition Display (LMON)

This command is used to display the circuit condition every 1.5 s. The command can be turned
off by entering [\].
The following circuit conditions may be displayed.
"Ready"
"Incoming Call Service"
"Outgoing Call Service"
"DSP Reset Processing"
"PT connect Processing"
"Error/Not Exist"
$ LMON
CO No.:
1:
2:

7.2.19 DTMF Information Display (PUTD)

This command is used to display the DTMF tones the VPS receives and sends.
In addition to the DTMF tones the following are displayed — the Incoming Call Service (Voice
Mail, Automated Attendant, Custom, and Interview) entered by the caller and the time periods
that the ports are enabled.
Type PUTD. The VPS will remain in this mode until "PUTD" is entered again. The default
setting for this mode for all ports is "OFF."
$ PUTD
Target Port : * *
$
To change the mode from "PUTD" to "OFF," Type PUTD again.
$ PUTD
Target Port : 00
Don't leave enabled after troubleshooting
$
Note: "*" means "enable" for the port
To set the mode for only 1 port, Type PUTD and the port number.
148
: Possible to serve
: Processing arrival service
: Processing sending service
: Processing DSP reset disposition
: Processing PT connect disposition
: DSP Card is not loaded
Status
Ready
Ready
"0" means "disable" for the port
SYSTEM MAINTENANCE AND TROUBLESHOOTING