Frame 1 Drive Lifting And Assembly (Cont'd) - Toshiba T300MVi MEDIUM VOLTAGE Instruction Manual

DRIVE INSTALLATION DRAWINGS (cont'd)

Frame 1 drive lifting and assembly (cont'd)

TO MOVE THE SECTIONS USE A FORKLIFT OF ADEQUATE CAPACITY
LIFT FROM THE SLOTS IN THE CHANNEL BASE ON THE TRANSFORMER SECTION.
THE INVERTER SECTION IS SHIPPED WITH 4x4 POSTS ATTACHED TO BOTTOM.
MAKE SURE THE FORKS EXTEND ENTIRELY THROUGH THE SECTION.
NOTE: OVERHEAD LIFTING PROVISIONS ARE PROVIDED ONLY FOR THE INVERTER SECTION.
AFTER THE SECTIONS ARE IN PLACE BOLT TOGETHER WITH WITH 1/2" HARDWARE.
THEN INSTALL AND WIRE THE FAN ASSEMBLIES.
CONNECT THE DC BUS CABLES TO THE MODULES AND PLUG IN THE CONTROL CONNECTOR
ASSEMBLE THE GROUND BUS SPLICE.
FAN CONTROL / POWER WIRE CONNECTOR
AND MOUNTING HOLES
CONTROL WIRE CONNECTOR
AND DC BUS CABLES
TOW MOTOR SLOTS
- 48
1/2 INCH HOLES
FOR JOINING CABINETS
LIFTING EYES