Frame H4P Module Lifting And Installation Continued - Toshiba T300MVi MEDIUM VOLTAGE Instruction Manual

DRIVE INSTALLATION DRAWINGS (cont'd)

Frame H4P module lifting and installation continued

B
A
Power Module Installation
1. Lower lifter tray to ground. Roll Power Module onto tray. Secure Power Module.(B)
2. Raise tray above Power Module support pan. Lower tray, inserting pins into holes in
front edge of support pan. (A) Set truck brake.
3. Unlatch Power Module (B). Roll Power Module from truck onto enclosure rails.
Power Module Reconnection
1. Reverse the procedure followed during disconnection and removal of Power Module.
2. Ensure that control signal cable and 120VAC supply cable are properly reconnected.
3. Reinstall all hardware previously removed.
4. Torque bus link connections (5/16-18 hdwr) to 10-15 ft-lbs.
Pin in front
edge of lift
tray
Power
Module
support pan
Lifting Attachment
Power Module Lifting
For lifting the Power Module after it is out of
the Cubicle use Lifting Attachment
GCI6724G055 and a lifting device rated at
1000 lbs. or more.
Secure Lifting Attachment to Power Module
with (4) ½ -13 Bolts.
- 71
PC94060P194