Panasonic KX-TG6500 Operating Instructions Manual page 98

Troubleshooting
Problem
An incoming message recorded
for a line is not played after
pressing [MESSAGE].
Memo messages are not
played after pressing
[MESSAGE].
General
Problem
The handset/base unit does not
work.
"Recharge battery" is
displayed, "
3
or the handset beeps
intermittently.
"Charge for 6 HRS" and
" " are displayed and the
4
handset does not work.
You charged the battery fully,
but "Recharge battery" is
still displayed and/or "
continues to flash, or "Charge
for 6 HRS" and "
displayed.
The CHARGE indicator does
not go out after the battery has
been charged.
If you cannot solve your
problem
98
• Select the line for that message by pressing
• You may have pressed [LINE SELECT] before
• Check the settings (p. 12–17).
• Check whether the dialing mode setting is
• Fully charge the battery (p. 16).
• Clean the charge contacts and charge again
• Check battery installation (p. 16).
• Unplug the base unit's AC adaptor to reset it.
• The handset has not been registered to the
• Re-install the battery (p. 16) and fully charge it.
• Fully charge the battery (p. 16, 17).
" flashes,
• The battery has been discharged. Fully charge
• Clean the charge contacts and charge again
" • The battery may need to be replaced. If you
3
" are
4
• This is normal.
• Visit our website:
• Contact us via the web at:
• Call our customer call center at:
Cause & Remedy
[LINE SELECT], then press [MESSAGE]
(p. 73).
pressing [MESSAGE]
again without pressing [LINE SELECT] (p. 73).
Cause & Remedy
correct (p. 21).
(p. 17).
Plug in, and try again.
base unit. Register the handset (p. 91, steps 5
and 6).
the battery (p. 16, 17).
(p. 17).
install a new battery, fully charge it (p. 16, 17).
http://www.panasonic.com/support
http://www.panasonic.com/contactinfo
1-800-211-PANA(7262)
.
Press [MESSAGE]