Display Fault/Error Codes For Steam Dryer - Kenmore 795.851**.900 Service Manual

PROBLEM
Cannot see steam
vapor at the
beginning of cycle.
The display shows
BULKY LOAD.
Odors remain in
clothing after
STEAM REFRESH.

8-3. Display Fault/Error Codes for Steam Dryer

The error codes below will be displayed when attempting to start a drying cycle, or after
activating the Diagnostic Test mode.
CHECKING PART
DISPLAY
Thermistor of blower
tE1
housing
Thermistor of blower
tE2
housing
Thermistor of steam
tE4
generator
E5
Water supply pump
Add water Steam generator
Wire Connection
PS
(Black-White-Red)
POSSIBLE CAUSES
• This is normal.
• MORE TIME button
pressed.
• STEAM REFRESH
did not remove odor
completely.
Outlet thermistor open or shorted.
Outlet thermistor open or shorted.
Steam generator thermistor open
or shorted.
When the pump valve is less than
10 in the test mode
Sensors do not detect that steam
generator is full within 60 seconds.
Wire Connection is wrong.
Wire Connection is loose.
• Steam is released at different stages of the cycle
for each option.
• Pressing the MORE TIME button several times will
set the cycle for a large load such as a comforter.
• Fabrics containing strong odors should be washed in
a normal cycle.
CAUSE
21
SOLUTIONS
REMARK
• tE1 error is displayed in the
drying cycle or test mode.
• Replace the steam generator.
• tE2 error is displayed in the
drying cycle or test mode.
• Replace the steam generator.
• tE4 error is only displayed in the
test mode.
• Replace the steam generator.
• tE5 error is only displayed in the
test mode.
• Check the connection between
harness wire and connector.
• Replace the water supply pump.
• If water in the steam feeder is
not enough this error may be
displayed. Fill the feeder and
restart the cycle.
• See the 9-11 page.
Guidance of the wire connection.
For only electric dryer.
*PS : "Power Supply"