Table of Contents
Advertisement
Field wiring instructions
Use copper wires only.
Solid wire:
Strained wire:
Torque of screw clamps:
2.8
Inserting the SIM card
Notice
Before inserting the SIM card, enter the PIN of the SIM card in the SINAUT
MD741-1 via the Web user interface. See Chapter 5.1.
Figure 2-3
1. After you have entered the PIN of the SIM card, disconnect the SINAUT
MD741-1 completely from the power supply.
2. The drawer for the SIM card is located on the back of the device. Right next to
the drawer for the SIM card in the housing aperture there is a small yellow
button. Press on this button with a pointed object, for example a pencil.
When the button is pressed the SIM card drawer comes out of the housing.
3. Place the SIM card in the drawer so that its gold-plated contacts remain visible.
4. Then push the drawer with the SIM card completely into the housing.
Notice
Do not under any circumstances insert or remove the SIM card during operation.
Doing so could damage the SIM card and the SINAUT MD741-1.
SINAUT MD741-1
C79000-G8976-C236-05
2
0,5...3 mm
0,5...2,5 mm
0,6...0,8 Nm
Inserting the SIM card
(AWG 20...18)
2
2 Setup
23
Advertisement
Table of Contents
