Table of Contents
Advertisement
● Code :
● C d
M2-1121
M2-1124
M2-1125
M2-1131
M2-1134
M2-1135
● Symptom / Cause :
Paper transport jam (paper Input section)
- The paper from the tray3 (or 4) has not reached to th
p p
the tray3 feed sensor.
- When you open and close the take away door, the pa
● Troubleshooting method :
1. Open the side & take away door. Remove the jamm
Close the Side door. After warm up, if same jam occ
2. Open the side & take away.
Remove the jammed paper between the feed roller
If there is any defective part in this area, replace it.
3. If the white idle roller of the take away door breaks a
release the inner cover and reassemble the idle rolle
4. Check if the wall connector of tray1 pick up
Reconnect the connector.
5. Enter the diagnostic mode, and check the feed sens
If the paper is contacting sensor and "Without paper
replace the sensor(0604-001393).
6. Check if the connector of the tray2 pick up unit on th
Reconnect it.
7. Replace the main board(JC92-02587A(for 8240) / JC
Service Manual
7. Troubles
● Error message :
● E
Paper jam inside of m
y (
)
shooting
machine.
e tray2 feed sensor within normal time after passing
y
aper has jammed at the tray2 feed sensor.
med paper.
curs, check the following.
of the tray2 pick up unit and tray1 feed roller.
away,
er.
unit(JC9
93-00070A) is connected properly.
sor test of the tray1 pick up unit.
r" message is displayed,
he pick up drive unit is connected properly.
C92-02587B(for 8230))
7-M
M-4
p
g
SAMSUNG ELECTRONICS
Advertisement
Table of Contents
Troubleshooting
