Side Joint Pba - Samsung SCX-82x0 series Service Manual

3.7.10 Side joint PBA

Perform the following procedure to remove the Side jo
1. Open the side unit.
2. Release the side joint board cover after removing
2 screws.
Push !
Service Manual
3.Replacemen nt Procedure
int PBA from the printer.
3. Unplug all connectors.
4. Remove 4 screws.
5. Release the side joint board.
CAUTION
When you reassemble the side joint board to the
side unit, make sure the harness arrangement is
correct.
The harness on the side joint board.
3-4 46
j
The harness of Face up Sensor.
SAMSUNG ELECTRONICS