Protocol, Baud Rate, Address Setup; Protocol And Baud Rate Setup - IC Realtime PTZ2300SIR User Manual

Ir analog intelligent speed dome

Hide thumbs Also See for PTZ2300SIR:

Table of Contents

2 Protocol, Baud Rate, Address Setup

Before you operate, you need to set address, baud rate and parity. Otherwise you can not control

the product!

Please configure the following settings before begin controlling dome:

Baud rate

Parity

Address

Note: Please reboot the speed dome to get all the setups activated!

Open the dial switch cover on the bracket, the interface is shown as below. See Figure 2-1. You can see

there are two dial switches on the PCB board.

The two dial switches can specify the speed dome parameter such as address, protocol, baud rate and

etc. For the baud rate dial switch buttons: 1-3 is NC, 4 is the 120Ω resistance, ON is to connect to the

120Ω resistance. When the button is ON, it is 1. In dial switch buttons, 1 is the lowest bit and the 8 is the

highest bit.

Open dial switch

cover

Please note this series speed dome can automatically recognize the industrial standard protocol,

PELCO-D. PELCO-P. usually you do not need to set the protocol.

Please refer to the baud rate sheet for detailed information.

Parity/Baud Rate

Setup

Figure 2-1

Address Setup

Table of Contents