Processor Fan - HP Pavilion HDX Entertainment Series Maintenance And Service Manual

Remove the video connector board:
1.
2.
3.
4.
Reverse this procedure to install the video connector board.

Processor fan

Description
Processor fan
NOTE:
right sides and rear panel of the computer. The computer uses two electric fans for ventilation. The fans
are controlled by a temperature sensor and are designed to turn on automatically when high temperature
conditions exist. These conditions are affected by high external temperatures, system power consumption,
power management/battery conservation configurations, battery fast charging, and software
requirements. Exhaust air is displaced through the ventilation grills located on the computer rear panel.
Before removing the processor fan, follow these steps:
1.
2.
3.
Downloaded from www.Manualslib.com
Rear cover (see Rear cover on page
e.
Top cover (see Top cover on page
f.
Subwoofer (see Subwoofer on page
g.
Disconnect the video connector board cable (1) from the system board.
Remove the Phillips PM2.5×4.0 screw (2) that secures the video connector board to the base
enclosure.
Route the video connector board cable under the processor heat sink pipe (3).
Remove the video connector board (4) from the base enclosure.
To properly ventilate the computer, allow at least a 7.6-cm (3-inch) clearance on the left and
Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
Disconnect all external devices connected to the computer.
Disconnect the power from the computer by first unplugging the power cord from the AC outlet and
then unplugging the AC adapter from the computer.
manuals search engine
53)
55)
67)
Component replacement procedures
Spare part number
448162-001
69