Speakersize; Preout Mode; Headphone Mode; Display Brightness - T+A R 1000 E User Manual

Speaker size
menu item

PreOut mode

menu item

Headphone mode

menu item

Display brightness

menu item
(screen brightness)

Display mode

menu item
Loudspeaker
Sets the size and bass response of the loudspeaker
SATELLITE
for very small loudspeakers (satellite speakers) with limited bass response.
The low-frequency bass signals (below 100 Hz) of the main channels are mixed
onto the subwoofer. If you are using SAT speakers a sub-woofer is a basic
necessity, otherwise bass response will be inadequate.
FULL-RANGE
for larger speakers.
The full, unrestricted range of frequencies is reproduced via the main channels.
If your system includes full-range speakers, no subwoofer is required. However,
under certain circumstances the use of a large, high-power subwoofer may still
be sensible in order to relieve the strain on the main loudspeakers during loud
passages, and passages with extreme low-frequency content.
The preamp outputs (PreOut) can either switched ON and OFF together with
the speaker outputs or they can be set to be permanently ON.
The „permanent ON" setting can be useful for example to supply audio signals
to an other room independently from the speaker state in the main room.
"Linked"
This setting enables the PreOut muting synchronously with the speaker outputs.
Switching ON/OFF all outputs is achieved by pressing the -button
(Mute).
"perm On"
This setting sets the PreOut outputs to be permantly switched ON.
The R 1000 E detects headphones automatically.
In the "Headphones only" setting the loudspeaker output and pre-amplifier
output are automatically switched off when headphones are connected. If you
wish to be able to control these outputs separately, select the "Phones +
speakers" setting.
At this point you can adjust the brightness of the integral screen to suit your per-
sonal preference for normal use; seven levels are available.
This menu item offers the choice between three different display operation
modes:

Always on

Temporary

Always off
Selecting 'Temporary' will switch the display is on for a short while each time
the R 1000 E is being operated. Shortly after operation the display will be
switched off again automatically.

The brightness of the display can be adjusted separately with the menu item
'Display Brightness' (see above).
15