T+A R 1000 E User Manual page 58

Streaming Client
The streaming client can
not connect to a network.
On the display the
indication
'SCL Connecting...'
is displayed.
Transmission interruptions
occur when listening to
internet radio stations.
Some internet radio stations
can not be received
Bad sound quality
certain internet radio
stations
USB Storage device is not
recognised
58
Cause 1 (cable LAN):
Network cable not properly connected
Remedy:
Connect network cable, check connection to router
Cause 2 (radio network):
USB-WLAN stick not connected, or connected while the device was already
switched on.
Remedy:
Switch the machine off, and connect the USB-WLAN stick supplied in the set.
Now switch the machine on, and enter the network parameters (see the section
entitled 'Network configuration').
Cause 3 (wireless LAN):
WLAN reception qualiy bad (low field strength). Possibly too much attenuated
by walls/ceilings on the transmission path.
Remedy:
Optimize location of receiver and transmitter antennas.
Alternative:
If transmission problems persist a so called ‚Power Line' network might be good
alternative to establish a good and stable network connection.
The best, safest and most secure network however will always be a cable LAN
network.
Cause 4:
Netzwork parameters not properly configured.
Remedy:
Configure the
configuration').
Cause 1:
The capacity of the internet radio station's server is at it's limit.
Remedy:
Choose a different station.
Cause 2:
Network problems occurred.
Remedy:
Check your network (see above).
Cause:
The internet radio station has been switched off, it transmits only at certain
hours of the day or it has changed ist internet address.
Remedy:
Try to get information from the website of the station regarding transmission
hours ans internet address (URL).
Try to establish a connection to the station at a later time.
bei Cause:
The station transmits with a low audio bandwidth (low bitrate).
Remedy:
Use stations transmitting at least at 128 kBit/s. This is the lowes recommended
bitrate for adequate sound quality. For good sound quality we recommend high
bitrates like 320 kBit/s
Cause 1:
The storage device (especially USB hard discs without separate power supply)
draws more electrical current from the USB interface than is permitted by the
USB standard.
Remedy:
Only use USB storage devices that conform to the USB standard or use storage
devices with own power supplies.
network parameters correctly (see chapter 'Network