Playback Of Directories; Search Function - T+A R 1000 E User Manual

Starting playback
Stopping playback
Skipping tracks

Playback of directories

Search function

Front panel display
Press the  button on the remote control handset or the machine's front
panel to start playback.
Pressing the  button halts playback.
A brief press on the  /  buttons during playback causes the
device to jump to the next or previous piece of music within the current playlist.
In addition to the facility to play back
individual folder content, it is also
possible to play back entire directories.
This is accomplished by selecting the
folder of the directory to be played,
then pressing the  button to
start playback. Playback commences
with the first entry in the list of content
to be played. If an entry in the list
should contain a folder with additional
sub-folders, the content of the lowest
folder is always played first. This is
followed by the content of the next
higher folder level, etc. (see diagram
right).
When you are navigating through lists you can call up the R 1000 E`s letter
search function at any time by briefly pressing the blue  button. The
screen now displays the message "Search". While this is on the screen, enter
up to eight letters or numerals using the remote control handset; the letters
assigned to the numeric buttons are printed below the buttons. To obtain a
particular letter, press the appropriate button repeatedly until the correct letter
appears on the screen. Before entering the next character you have to wait until
the cursor is displayed again. Press the  button to erase any letter.
After pressing the  button or after a brief delay with no further input the
R 1000 E moves to the first entry in the list which starts with the characters you
entered.

If the text searched for is not found the best matching result will be shown. You
can abort the search using the -button.
The function searches only the current folder. Eventually existing subfolders are
ignored.

The R 1000 E provides different screen displays for the Streaming Client.
A long press on the –button on the remote control handset is used to
switch between the display modes.

Large-format display:
Enlarged display of the most important information, clearly legible even from
a distance

Detail display:
Small-text display showing a large number of additional information points,
e.g. bit rate etc.
31