Bosch TES 501 SERIES Operating Instructions Manual page 35

en
Specially developed and suitable descal-
ing and cleaning tablets are available
from retailers or customer service.
Order number
Cleaning
tablets
Descaling
tablets
Important: If there is a water filter in the
water tank (16), it must be removed before
starting the service programme.
To start the service programme, press and
hold the service button (12) for at least
5 seconds.
Information: The service button (12) flash­
es while the programme is running.
H
LED lights up.
● Empty the drip tray (8) and reinsert it.
The appliance rinses twice.
G
LED lights up.
● Open the drawer (4).
● Drop a Bosch cleaning tablet into the
drawer (4) and close it.
● Press the start button (10).
D
LED lights up.
● Fill the empty water tank (16) with luke­
warm water up to the 0.5l mark and then
dissolve two Bosch descaling tablets in
this water.
● Press the start button (10).
The service programme will now run for
approximately 10 minutes.
TES501_1DE.indb 35
Retailer Customer
service
TCZ6001 310575
TCZ6002 310967
h
LED lights up.
● Place a container with a capacity of at
least 0.5 litres under the milk frother
outlet (6).
● Pull out the milk frother (6) to open it.
The service programme will now run for
approximately 12 minutes.
D
LED lights up.
● Rinse the water tank (16) and refill it with
fresh water up to the max mark.
● Press the start button (10).
The service programme will now run for
approximately 30 seconds and rinse the
appliance.
h
LED lights up.
● Push the milk frother (6) in to close it.
The service programme will now run for
approximately 8 minutes.
H
LED lights up.
● Empty the drip tray (8) and reinsert it.
If you are using a filter, reinsert it now.
The appliance has been cleaned, descaled
and is ready for use again.
35
TES501.. 08/2011
05.08.2011 15:34:52