Transport; Preparations; Mowing Procedure - Viking MA 339 C Instruction Manual

shock. Therefore, check the electric cable
regularly for signs of damage or ageing
(brittleness).
Only connect the charger to a properly
installed socket. The power supply must
be protected via a residual current-
operated protective device with a release
current of maximum 30mA.
Never perform repairs to the charger and
particularly not to the power cable or mains
plug. Have damaged electric cables
repaired by a qualified electrician.
When disconnecting the charger from the
mains power supply, always pull on the
mains plug and not on the electric cable.
Route and label the electric cable in such
a way that it cannot be damaged and does
not constitute a hazard – Prevent risk of
stumbling.
Do not use the electric cable otherwise
than for its intended purpose, e.g. for
carrying or suspending the charger.

4.4 Transport

Always wear gloves to prevent
injuries from sharp-edged
components.
Switch off the machine prior to
transport, allow the blade to
come to a standstill and remove the safety
plug.
Note the information in the "Transport"
section ( 14.) when lifting the machine.
Take the weight of the machine into
account and use suitable loading aids
(loading ramps, lifters) if necessary.
Avoid contact with the blade when lifting
and carrying the machine.
0478 131 9917 G - EN
Only transport the machine once the motor
has cooled down.
Secure the machine and any machine
components being transported (e.g. grass
catcher box) on the load floor using
adequately-dimensioned fastening
material (belts, ropes etc.).
When transporting the machine, always
observe regional legislation, especially
regarding load security and the transport
of objects on load floors.
Do not leave the battery inside a vehicle
and never expose it to direct sunlight.
Lithium-ion batteries must be treated with
special care during transport. In particular,
it must be ensured that short circuits are
prevented during transport of the batteries.
For this reason, keep the original
cardboard packaging of the battery and
always transport STIHL batteries either in
the undamaged original packaging or in
the lawn mower.

4.5 Preparations

Persons who are not familiar with the
instruction manual are not permitted to use
the machine.
Observe the local regulations regarding
permitted operating times for gardening
power tools.
Always wear robust shoes and
long trousers when mowing.
Never mow barefoot or in
sandals.
Carefully inspect the complete area on
which the machine is to be used and
remove any large stones, sticks, wires,
bones or other foreign objects which could
be thrown up by the machine.
Before use, perform a visual check to
ensure that the cutting tool, fastening
screws and entire cutting unit are in good
condition, check particularly for secure
seating, damage and wear (
Replace all worn or damaged parts before
using the machine. Replace any illegible or
damaged danger signs and warnings on
the machine. Your VIKING dealer has a
stock of replacement stickers.
Never use the mower with damaged safety
devices, without functioning motor brake
or attached safety devices, e.g. without the
discharge flap or the grass-catching unit.
For safety reasons, always use an
undamaged grass catcher box.
The switch mechanisms installed in the
machine must not be removed or
bypassed (e.g. by tying the motorstop
lever to the handlebar).
Follow the instructions in the "Battery"
( 4.2) and "Charger" ( 4.3) sections.

4.6 Mowing procedure

Keep others, particularly
children, and animals out of the
danger area. Make sure that
others are not endangered.
Do not mow at ambient temperatures
below +5°C (41°F).
VIKING recommends wearing
hearing protection at all times
when working. If the sound
pressure level at workplace
exceeds 80 dB(A), hearing protection
should always be worn.
13.6).
37