English
Replacing the V-belt
3
3
4
3 1
The arrow on the tensioning nut (1)
N
must point to 0 – to this end, turn the
tensioning nut with the combination
wrench counterclockwise –
approx. 1/4 turn, as far as
possible = 0
Remove screw (2)
N
Remove the V-belt guard and
N
"bearing and guard"
Remove the screws (3) from the
N
starter cover
Remove the starter cover (4)
N
Remove the defective V-belt from
N
the cast arm.
carefully fit a new V-belt in the cast
N
arm and in the V-belt pulley on the
short block
Fit the starter cover
N
Hold the bearing with guard against
N
the cast arm
32
2
2
Fit the V-belt in the front poly V-belt
N
pulley (5)
Line up the threaded holes in the
N
bearing plate with the oblong holes
in the cast arm
Slide on the V-bekt guard
N
Screw in the hexagon head
N
screws (2) as far as possible – do
not tighten them down yet
Continue as described in the chapter
"Tensioning the V-belt".
Cut-off machine cart
5
The cut-off machine can be mounted on
the STIHL cut-off machine cart FW 20
(special accessory) in a few easy steps.
The cut-off machine cart makes it easier
to
repair damaged roadways
–
apply roadway markings
–
cut expansion joints
–
TS 400